Kb-electronics KBVF-23P Manual de usuario descargar pdf (Pagina 37)

TABLE 4 – DRIVE OPERATING CONDITION & STATUS LED INDICATOR

LED Drive Status

Color and

Flash Sequence Flash Rate

Color and Sequence

After Recovered Fault

(Status)

Normal Operation (Run) Green 1 Sec. On / Off —

Overload (120% – 160% Full Load) Red On Continuously Green

t (Drive Timed Out) Red 0.25 Sec. On / Off —

Short Circuit Red 1 Sec. On / Off —

Undervoltage Red / Yellow 0.25 Sec. On / Off Red / Yellow / Green

Overvoltage Red / Yellow 1 Sec. On / Off Red / Yellow / Green

Stop Yellow On Continuously —

Phase Loss Detection

1,2

Yellow 0.04 Sec. On / 0.06 Sec. Off —

Communication Error

Green / Red 1 Sec. On / Off Green

PWR

(Power)

Buss and Logic Power Supply Green On Continuously —

Notes: 1. Phase Loss Detection: Models KBVF-23P, 24P, 29, 45, 48. 2. Requires AC line restart. 3. With DIVF Modbus

Communication Module Installed. 4. All LED flash rates, after recovered faults, are 1 Sec. On / Off. 5. Drive will require

manual restart to return the Status LED color to its normal flashing green.

12 DIAGNOSTIC LEDS

The drive contains two diagnostic LEDs to display the drive’s operational status. See Figure 4, on

page 20, for the location of the “PWR” and “ST” LEDs.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44 45

Sin comentarios

Kb-electronics KBVF-23P Manual de usuario Pagina 37